Please be aware that our couriers are currently experiencing critical delays of between 3-7 working days.

IPONE Clutch One - Mineral Clutch Fluid 125ml

Regular price $9.99

$0-$200 shipping is $9.95 New Zealand wide.        $200-$300 shipping is $7.00 New Zealand wide.                   $300+ free shipping New Zealand wide.

CLUTCH ONE is a mineral transmission oil for hydraulic clutch controls of road and off-road motorcycles.

CLUTCH ONE has been formulated to ensure progressivity, consistency and ease of use of your clutch control. Its additives guarantee a quick and effective reaction of the clutch both hot and cold. The fluid is compatible with seals.

Its red color is clearly visible during purging, its tube format with pour spout is convenient to perform a precise dosage, without putting any aside!


  • Hydraulic clutch
  • Compatible with sealing joints
  • Mineral
  • Progressiveness, consistency and ease of use of the clutch actuation system
  • 125mls


How to change the clutch oil of a motorcycle:

1) First, disassemble the clutch master cylinder cover, located on the left side above the clutch lever. Once the cover is removed, the oil pan buffle must be removed as well.
Do not forget to protect the fairings of your motorcycle to avoid damaging the paints. In case of leakage, clean immediately with a clean cloth.
2) Remove the cap protecting the drain screw on the clutch receiver.
3) Install a transparent hose on the drain screw and a container at the end of the hose to recover the old liquid.
4) Place a small amount of (new) clutch fluid in this container to prevent the hose from working on the air during the purge.
5) Press the clutch lever several times and then hold it. While crushing the lever, slightly open the purge screw. The used liquid (black) will come out and flow into the container. When the liquid no longer flows, screw back the screw.
6) You can now release the lever. You will then see air bubbles escaping through the hose or the master cylinder.
7) Repeat this operation, adding new liquid to the master cylinder, until you see no more bubbles. Then put the cap back on the screw head.
8) Now put the rubber back on and adjust the liquid level, then put the lid back on and tighten the screws. 

For a perfect bleed, use a pneumatic bleeder.

It is recommended that the clutch fluid be changed annually or every 10,000 km. Still, we recommend that you refer to your maintenance manual and follow the manufacturer’s recommendations.

Check out all workshop maintenance and workshop tools